Technical Specifications - HP ProLiant ML150 Quickspecs

QuickSpecs

Technical Specifications

System Unit Dimensions (WxHxD)
Weight (approximate)
Input Requirements
(per power supply)
BTU Rating
Power Specifications
Power Supply Output
Power
(per power supply)
System Inlet
Temperature
Relative Humidity
(non-condensing)
Altitude
DA - 13249 North America — Version 33 — September 24, 2012
HP ProLiant ML150 Generation 6 (G6)
7.87 x 16.81 x 24.13 in (200 x 427 x 613 mm) (W/O foot stand)
Maximum:
(All hard drives, power
supplies and processors
installed)
Minimum:
(One hard drive, power
supply and processor
installed)
Range Input Voltage
Normal Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
(optional 750W RPS)
Maximum
(optional 750W RPS)
To review typical power ratings use the Power Advisor which is available via
the online tool located at URL:
Rated Steady-State Power 460W (750W) at 100 VAC for system
Maximum Peak Power
Operating
Non-Operating
Operating
Non-operating**
Operating
Non-Operating
30 kg
16kg
90 to 135 VAC
180 to 265 VAC
100 to 127 VAC
200 to 240 VAC
load 10A at 100 to 127 VAC
5A at 200 to 240 VAC
47 to 66 Hz
760 W Max
(940W) Max
1814 BTU
(2243) BTU
www.hp.com/go/proliant-energy-efficient
460W (750W) at 200 VAC
460W (750W) at 100 VAC
460W (750W) at 200 VAC
50° to 95° F (10° to 35° C) at sea level with an
altitude derating of 1.8°F per 1,000 ft (1.0° C per
every 305 m) above sea level to a maximum of
10,000 ft (3050 m) no direct sustained sunlight .
Maximum rate of change is 18°F/hr (10°C/hr). The
upper limit may be limited by the type and
number of options installed. System performance
may be reduced if operating with a fan fault or
above 86°F (30°C).
-40° to 140° F (-30° to 60° C)
10% to 90% relative humidity (Rh), 82.4°F (28°C)
maximum wet bulb temperature, non-
condensing.
10% to 95% relative humidity (Rh), 101.7°F
(38.7°C) maximum wet bulb temperature, non-
condensing.
10,000 ft (3000m). Maximum allowable altitude
change rate is 1°C per 300m.
30,000 ft (9144m). Maximum allowable altitude
change rate is 1°C per 300m.
Page 41