Mode Selection; Switching Between Incident Light Metering And Reflected Light Metering; How To Fit The Lumidisc; How To Remove The Lumidisc - Sekonic FLASHMATE L-308BII Operating Instructions Manual

3. Mode Selection

Your L-308Bll can measure both incident and reflected light in both ambient light and flash light
(electronic flash or flash bulb) modes. You can switch the modes as follows:
3.1 Switching between incident light metering and reflected light
metering
Slide the lumisphere and stop it at the clicking position of "a" or "b" (See Fig.1 and 2).
Fig. 1 Incident light metering
Caution:
3.2

How to fit the Lumidisc

depress the strap eyelet (C) toward the L-308Bll body. (See Fig. 7)
Fig. 4 Lumidisc
3.3

How to remove the Lumidisc

Take reverse procedures described above to remove the Lumidisc.
Caution: You may break the lumidisc if you do not take care when fitting and removin g ,
3
[Measured light]
see Page 7.
Fig. 2 Reflected light metering
Fig. 5
[Mode/display method]
Lumisphere
b
Fig. 6 Fig. 7
Fig. 3
umisphere