Related Manuals for Sekonic DIGI LITE L-318B
Summary of Contents for Sekonic DIGI LITE L-318B
- Page 2 PREPARING METER FOR OPERATION Battery check: Place a battery in battery chamber correctly, Then b.c. mark and bar symbols and switch the meter ON are displayed for a second. Number of bar symbols shows degree of battery capacity. If battery is weak to give correct readings, b.c. mark is blinking or disappears.
- Page 3 2. For measuring illumination contrast: Mount Lumidisc to swivel head. Switch the meter ON and point Lumidisc directly toward center of main light. Press measuring switch in EV mode and read-out the measured value. In the same manner, read the EV number of fill-in light. Difference between EV numbers of main and fill-in lights becomes contrast ratio (refer to Table 1).
- Page 4 @ Swivel head @ Liquid crystal display Power switch Measuring switch 8 UP/DOWN key @ IS0 selecting key...
- Page 5 @ Battery chamber @ Lumisphere 0 Lumidisc b Lumigrid...
-
Page 6: Technical Data
TECHNICAL DATA Specifications Measuring range : EV(-) 1 -EV 19.9/ISO 100 Calibration constants: C=340 K=12.5 Measuring element Silicon Photo Diode Measuring method Time-priority and EV measurements Measuring accuracy : 0.1 EV in repeating measurements Film speed ISO 3-8000 F/stop : f/1.0-f/90 and bar symbols 0.1 -0.9 Bar-dot symbols at 1/2 f-stop increments are also displayed at the lower part of display board. - Page 7 Table 1 Table 2 Viewfinder 5° By using this viewfinder the 5' spot meas- urement is available. It makes you possible to measure reflected light of distant subject without going up close to the subject, or to check reflected light from small part of the subject.
- Page 8 SEKONIC CO.,LTD. 7-24-14, Oizumi-Gakuen-cho, Nerima-ku, Tokyo, Japan Phone (03) 3978-5155 Telex J34376 SEKONIC Fax (03) 3978-5229 Cable SEKONIC TOKYO...