Auto Power Off; Iso Film Speed Setup; Light-Receiving Method Setup - Sekonic MULTIMASTER L-408 Operating Instructions Manual

NOTES 0 You can sustain battery level display by holding down the Power switch.
and then goes out.
battery.
5.3 Auto Power-off
To save battery capacity, the L-408 is automatically turned off (and all readings are
erased) 10 minutes after your last operation.
NOTE
settings (such as mode selection, exposure setup and measured
values) are saved. They are displayed again when the POWER switch
is turned on.
5.4 IS0 film speed setup
Hold down the IS0 button (@iJ) and press the UP or
DOWN button (c=@) to set the IS0 film speed. The UP
button is used to select higher film speed, and the DOWN
button for more than one second continuously increases
or decreases the film speed.
NOTE
The new calculated value is displayed when the film speed is changed after taking the
measurement.

5.5 Light-receiving method setup

Select incident light metering (with lumisphere in the UP or DOWN position) or
reflected tight metering (with 5-degree spot meter).
Eyepiece
cover
Closed
Incident light metering
8
(with cover closed)
-
Open
Eyepiece
cover
Reflected light metering
(with cover open)
- -
- - -