Antenna Select Programming; S-Meter; Signal Level - AOR AR2300 Operating Manual

3-12-1 Antenna Select programming

Up to 10 receive frequency ranges can be programmed and assigned to
an antenna input.
If the above programming is not made, antenna 1 is selected.
AP To add new frequency range, use APn xxxx.xxxxxx yyyy.yyyyyy
To assign new frequency range in a specific location,
AP% --- Display programmed frequency range for both antenna connectors.
(Frequency below 25MHz cannot be set.)
AD To delete specific programmed frequency ranges,
To delete all programmed frequency ranges on a specific antenna connector,

3-13 S-meter

3-13-1 Signal level

LM To read: LM <CR>
Response
use APnmm xxxx.xxxxxx yyyy.yyyyyy
use ADnm.
use ADn%.
To delete entire programmed memory contents, use AD%%.
n: 1, 2 (antenna connector)
xxxx.xxxxxx low end frequency (MHz)
yyyy.yyyyyy high end frequency (MHz)
n: 1, 2 (antenna connector)
mm: memory location (00 ~ 09)
xxxx.xxxxxx low end frequency (MHz)
yyyy.yyyyyy high end frequency (MHz)
n: 1, 2 (antenna connector)
m: memory location (0 ~ 9)
n: 1, 2 (antenna connector)
LMnnn.nc
nnn.n: Relative level in dB
c: Squelch status
no display : squelch closed
P: squelch open
V: voice squelch open
A: APCO25 mode
E: APCO25 (encrypted)
D: CTCSS / CTS squelch
28