Lan (Local Area Network) Control Commands; Readout Settings From The Optional Lan-Box; Write Settings To The Lan-Box; Ipv4 Address - AOR AR2300 Operating Manual

11. LAN (Local Area Network) control commands

Below is a command format for LAN control:
(Note: No space must be inserted between the sub command and parameter.)

11-1 Readout settings from the optional LAN-box

IP RED
(Note: Each sub command will display all its stored data value on the
AR2300 until data readout is completed. Therefore, it is recommended
to use this command before changing /displaying the LAN settings. )

11-2 Write settings to the LAN-box

IP WRT
(Note: This command is to write parameters to the LANBox.
Beware that using this command will write all parameters stored on the
AR2300 to the LANBox before executing the IP RED command.
This may result in the loss of parameters on the LANBox.)

11-3 IPv4 address

IP IPF
To read: IP IPF<CR>
Response: IP IPFx.x.x.x

11-4 Mask address

IP
MSK
To read: IP MSK<CR>
Response: IP MSKx.x.x.x

11-5 Gateway address

IP GAT
To read: IP GAT<CR>
Response: IP GATx.x.x.x
45
IP sub command parameter
IP RED
IP WRT
IP IPFx.x.x.x
IP MSKx.x.x.x
IP GATx.x.x.x
x: 0 ~ 255 (IP address)
(default: 192.168.0.234)
x: 0 ~ 255 (Mask address)
(default: 255.255.255.0)
x: 0 ~ 255 (Gateway address)
(default: 192.168.0.1)