Antenna Input - AOR AR5001D Operating Manual

The [PASS] key is also used to selec t on/off of certain options such as step adjust and select defaults in
other menus.
MHz – ENT/TEXT
This k ey has three functions.
MHz – This key is used to enter frequencies as MHz in VFO mode.
For example, to set a frequency of 88.300 MHz, enter the key sequence [8][8][.][3][MHz].
There is no need to add the remaining zeros to the right once the [MHz] key is pressed.
ENT – This key is used to confirm entry in most menus.
If this key is held for two seconds in VFO mode, the AR5001D goes in to memory write mode.
Use the main dial knob to select the desired memory channel number, sub dial for memory bank to
store into memory. Press this key again to enter a memory text screen o f up to 12 characters to be
added to each memory channel.
T EXT – Press the [FUNC] key, and then press the [MHz] key to display the memory texts.
ATT – ANT
This k ey is used to select the RF attenuator menu. The menu has a selection of AUTO, AMP 0 dB, 0 dB,
-10 dB, or -20 dB.
Press the [FUNC] key, and then press the [ATT] key to activate the antenna input selection menu.
The menu has a selection of 1, 2, 3, 4, and PRG. To use the antenna 3 and 4, an optional AS5001
antenna relay will be re quired.
CLR
The CLEAR key is used to cancel frequency entry during programming or exit from a menu.
UP - MAIN
In VFO mode, press this key to change the displayed frequency to be incremented in an upward direction
by one step.
In VFO mode, press and hold this key for two seconds to activate frequency search.
In memory rea d mode, press and hold this key for two seconds to activate scan.
In memory text input mode , this key will move the curs or to the next space.
In dual band/dual frequency mode, press the [FUNC] key, and then press and hold this key to activate
the audio level b alance a djust menu for the main band.
20