The Furniture Door; Fixing To The Adjacent Units - Zanussi ZDS 699 Instruction Booklet

The furniture door

The door of this appliance is designed for the
overlay of a panel having the following dimensions:
Width 596 mm max
Height * 50 - 120 mm max
Thickness 20 mm max
* The height of the panel depends on the height of
the kitchen plinth.
Attention
The panel height should be no more than
indicated, otherwise complete opening of the door
will no longer be possible as the panel hits against
the dishwasher plinth.
Mounting the furniture door
1. Drill the panel with a Ø 2 x 12 bit according to
the dimensions indicated in the figure.
2. Fix the panel to the cross bar provided with 2
screws 3,5 x 16.
3. Fix the cross bar to the dishwasher door with 2
screws 3,5 x 16 after having inserted the two
hooks of the cross bar on the lower section of
the door.

Fixing to the adjacent units

To prevent the dishwasher tilting, it must be
secured to either the worktop or adjacent kitchen
cabinet/wall using the brackets supplied. Insert the
two fixing brackets into the slots provided in the top
front part of the dishwasher as shown in the figure.
Secure the brackets to adjacent units with the
3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the brackets
provided.
Failure to do this could cause damage or
injury.
Attention!
The sides of the dishwasher must never
be drilled to prevent damage to hydraulic
components.
II71
458 458
II69
II54
54
II70
PFI55GB