Operating Sequence - Zanussi ZDS 699 Instruction Booklet

Operating sequence

1. Check the filters
Ensure they are clean and properly
positioned (see "Maintenance and
cleaning").
2. Press the On/Off pushbutton
In the display will appear the indication of
the last selected programme and it's
corresponding phases indicator lights will
come on.
If the door is open also the "door open"
indicator light will illuminate.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into
the dispenser according to the "Washing
programmes" chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the
programme without "delay
start"
Press the "programme selector"
pushbutton until in the digital display
appears the number of the selected
programme.
The following options may also be
selected:
a- Half load by pressing the corresponding
pushbutton.
b- Eco drying or No drying by pressing the
corresponding pushbutton.
Press "programme start" pushbutton, an
audible advises you that the programme
has started.
In the display will appear the running time
of the programme and the indicator lights
of the phases will turn off except for the
indicator light of the phase underway.
The time in the digital display will start to
decrease from minute in minute.
Pressing the "programme selector"
pushbutton while the programme is running
in the digital display will appear the
number of the programme underway.
If the door is opened during the run of the
programme the phase underway will be
interrupted, in the digital display will appear
the number of the programme, the indicator
light of the interrupted phase will start to
flash and the indicator light "open door" will
illuminate.
Once closed the door the programme will
start from the point where it was
interrupted.
44 POS26GB