Table of Contents
Advertisement
8b. Setting and starting the
programme with "delay start"
Once a programme and eventual options
have been setted for the "delay start"
proceed as follows:
Press the "delay start" pushbutton, in the
digital display will appear "h0". Press the
button again to select the number of hours
by which you wish to delay the programme
start, up to a maximum of 12 hours.
The delay start will not modify the settings
made previously .
To set to zero the time setting press the
"delay start" pushbutton until "h0" appears
in the digital display.
Press the "programme start" pushbutton, in
the digital display the time to go before the
start of the programme will be indicated
with step of 1 hour.
You are informed of the operating of the
countdown by a flashing "h" in the digital
display.
Once the countdown has ended the
programme will start.
9.
At the end of the washing
programme
The dishwasher will automatically stop and
an intermittent audible signal informs you
that the programme has ended.
3 flashing horizontal lines appear in the
digital display and all the indicator lights
turn off.
To return in setting mode press any of the
pushbuttons or switch off and then switch
on the dishwasher.
The dishwasher can now be opened.
If the dishwasher door remains closed,
the turbo drying will go on performing
for a few minutes, this will allow a
further dehumidification.
10. To cancel a programme in
progress
Press the "programme start" pushbutton for
5 seconds to cancel the setting of the
programme under way.
All the indicator lights will turn off and 3
horizontal lines will appear in the digital
display. After 3 seconds the dishwasher will
return in setting mode.
It is now possible to select a new washing
programme.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Caution
Do not open the door during the hot
phase: this may cause hot water
escape.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
45
POS27GB
Advertisement
Table of Contents
