Table of Contents
Advertisement
Filling with salt
Only use salt specifically designed for use
in dishwasher.
All other types of salt not specifically
designed for use in dishwasher, specially
table salt, will damage the water softener.
Only fill with salt just before starting one
of the complete washing programmes (not
the Rinse and Hold programme).This will
prevent any grains of salt or salty water,
which may have been spilled, remaining
on the bottom of the machine for any
period of time, which may cause
corrosion.
To fill:
1. To fill with salt, unscrew the cap of the salt
container.
2. Pour 1 litre of water inside the container,
or until it is full (this is necessary only
before filling with salt for the first time).
3. Then using the funnel provided, pour in the salt
until the container is full.
Do not worry if water over flows from the unit
when filling with salt, this is quite normal.
4. Replace the cap making sure that there is no
trace of salt on the screw thread or on the
gasket.
5. Screw on the cap tightly.
The salt container will require topping up
periodically.
The "Salt" indicator light on the control panel will
illuminate when the salt has finished, and requires
refilling. The salt container has always some water
inside which will normally overflow when refilling
with salt.
The "Salt" indicator light can remain
illuminated for 2 - 6 hours after salt has
been replenished, assuming the
dishwasher remains switched on. If you
are using salts that take longer to
dissolve then this can take longer. The
function of the dishwasher is not affected.
SR06
36
PFS07GB
Advertisement
Table of Contents
