Filling With Dishwasher Salt - Zanussi ZDI101 User Manual

Setting the water softener manually (see table)
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must be switched off .
Press and hold the start/cancel button and turn the
programme selector dial clockwise till the first pro-
gramme.
Keep the button pressed until the programme selector
indicator light and the start/cancel indicator light start
flashing.

Filling with dishwasher salt

CAUTION!
Use only special salt suitable for dishwashers.
Set switch to position 1 or
2
The water softener is factory set at position 2.
Release the button. The end of programme indicator
light will flash. The number of flashes corresponds to
current level set.
The end of programme indicator light might flash 5
times, for example. The flashing is repeated every 5
seconds.
To change the level, press the start/cancel button.
Each time the button is pressed the level increases.
(Level 1 follows level 10).
The end of programme indicator light indicates the new
setting.
To memorise the operation, turn the programme se-
lector dial to position off.
9