Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDI101
Summary of Contents for Zanussi ZDI101
- Page 1 User manual Dishwasher ZDI101...
-
Page 2: Table Of Contents
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. -
Page 3: Safety Information
Safety information In the interest of your safety and to ensure the ried out by inexperienced persons will cause correct use, before installing and first using the injury or serious malfunctioning. Contact appliance, read this user manual carefully, in- your local Service Force Centre. Always in- cluding its hints and warnings. -
Page 4: Control Panel
Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine. - Page 5 Programme selector dial and On/Off switch • when in this position, the machine is switched off (corresponding light off), • when the marker on the dial corresponds with a programme, the machine is switched on and a pro- gramme is selected (programme selector indicator light on) Start/cancel button •...
-
Page 6: Washing Programmes
Indicator lights End of programme indicator light Illuminates when the washing programme has ended. Switch off the dishwasher by returning the programme selector dial to the Off position. The On/Off indicator light turns off. It also has added functions of visual signalling as: –... -
Page 7: First Use
Programme Half load Degree of soil Type of load Programme de- scription Rinse and Hold Any. 1 cold rinse (to Partial load (to be completed later in the avoid food scraps day). from sticking together). This programme does not require the use of detergent. -
Page 8: Set The Water Softener
– Fill up the salt and rinse aid container. – Adjust the water hardness setting according to the hardness of the water in your area. – Adjust the water hardness setting to the highest level and perform 1 normal washing –... -
Page 9: Filling With Dishwasher Salt
Setting the water softener manually (see table) The water softener is factory set at position 2. Set switch to position 1 or Setting the water softener electronically (see table) The water softener is factory set at position 5. The dishwasher must be switched off . Release the button. -
Page 10: Filling With Rinse Aid
Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. ter. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. -
Page 11: Adjusting The Dosage Of Rinse Aid
Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max" the lid and press until it locks. CAUTION! Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). -
Page 12: Loading Cutlery And Dishes
Open the lid. Set the dosage level. (The Close the lid and press un- dose is factory set in po- til it locks. sition 4). Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each other. - Page 13 For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is pearls handles. specially marked as being dishwasher-safe by the manufacturer.
-
Page 14: Upper Basket
Load upper basket. Light For taller items, the cup If plates are to be loaded in the upper basket: load items (plastic bowls etc.) racks can be folded up- them starting from the rear positions; tilting them must be loaded in the up- wards. -
Page 15: Use Of Detergent
Use of detergent IMPORTANT! Observe the manufacturer’s dosing and stor- age recommendations. Only use detergents suitable for dishwashers. Open the lid. Fill in the detergent in Observe the dosing lev- compartment A. els. For programmes with pre- When using detergent Close the lid. -
Page 16: Care And Cleaning
Care and cleaning Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. In- correct repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com-... -
Page 17: Environmental Concerns
use abrasive products, scouring pads or sol- Frost precautions vent (acetone, trichloroethylene etc..). Avoid placing the machine in a location where the temperature is below 0°C. If this is Internal cleaning unavoidable, empty the machine, close the ap- Ensure that the seals around the door, the de- pliance door, disconnect the water inlet pipe tergent and rinse aid dispensers are cleaned and empty it. -
Page 18: Something Not Working
product. For more detailed information about service or the shop where you purchased the recycling of this product, please contact your product. local council, your household waste disposal Something not working The dishwasher will not start or stops during Switch off the dishwasher, open the door and operation. - Page 19 Fault code and malfunction Possible cause and solution • The programme does not start • The dishwasher’s door has not been properly closed Close the door • The main plug is not plugged in Insert the main plug • The fuse has blown out in the household fuse box Replace the fuse •...
-
Page 20: Technical Data
The wash results are not satisfactory The dishes are not clean • The wrong washing programme has been selected. • The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. -
Page 21: Consumption Values
Noise level dB(A) Consumption values The consumption values are intended as a iations of the power supply and the amount of guide and depends on the pressure and the dishes. temperature of the water and also by the var- Consumption values Programme Programme duration (in Energy consumption (in... -
Page 22: Installation
Upper basket Cutlery basket Lower basket cup racks: position A Installation WARNING! WARNING! Any electrical and/or plumbing work required to Only use, for connection to the water mains, install this appliance should be carried out by a new hose-set; old hose-set must not be reused. qualified electrician and/or plumber or compe- CAUTION! tent person. -
Page 23: Drain Hose
If the water inlet hose leaks, the safety valve Therefore do not immerse the water inlet hose cuts off the water supply. or the safety valve in water. Take care when installing the water inlet hose . Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve. -
Page 24: Electrical Connection
Electrical connection WARNING! The dishwasher must be secured against tilting. CAUTION! Therefore make sure that the counter it is fixed Safety standards require the appliance to be under, is suitably secured to a fixed structure earthed. (adjacent kitchen units cabinets, wall). Prior to using the appliance for the first time, This dishwasher is designed to be fitted under ensure that the rated voltage and type of supply... - Page 28 www.electrolux.com 156993290-00-25072007 Subject to change without notice...