Table of Contents
Advertisement
WARNING!
Only use, for connection to the water mains,
new hose-set; old hose-set must not be reused.
CAUTION!
If the machine is connected to new pipes or
pipes which have not been used for a long time,
Inlet hose
Connect the inlet hose to a water tap with an external
thread of 3/4 .
The inlet hose can be turned either to the left or the
right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water
leaks.
Drain hose
Connect drain hose to
the sink. Secure it with
the supplied hose clamp.
24
Required height: 30 to
100 cm above bottom of
the dishwasher.
you should run the water for a few minutes be-
fore connecting the inlet hose.
Ensure that the hoses
are not kinked, crushed
or entangled.
When connecting the
drain hose to an under
sink trap spigot, the en-
tire plastic membrane
(A) must be removed.
Failure to remove all the
membrane will result in
food particles building up
over time eventually
blocking the dishwasher
drain hose spigot.
Advertisement
Table of Contents
