Table of Contents
Advertisement
156999670en.qxp
3/6/2006
CAUTION!
If the machine is connected to new pipes or pipes which have not been used for a long time, you
should run the water for a few minutes before connecting the inlet hose.
Inlet hose
Connect the inlet hose to a water tap with an
external thread of 3/4".
The inlet hose can be turned either to the left or the
right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water
leaks.
Ensure that the hoses
are not kinked, crushed
or entangled.
Electrical connection
WARNING!
Safety standards require the appliance to be
●
earthed. The manufacturer accepts no
liability for failure to observe the above
safety precautions.
Prior to using the appliance for the first time,
●
ensure that the rated voltage and type of
20
2:10 PM
Pagina 20
Drain hose
- Connect drain hose to the sink. Secure it with the
supplied hose clamp.
- Required height: 30 to 100 cm above bottom of
the dishwasher.
- If you use a drain hose extension the total length
should not be longer than 4 metres. Likewise the
internal diameter of the couplings used for
connections to the waste outlet must be no
smaller than the diameter of the hose provided.
supply on the rating plate match that of the
supply where the appliance is to be installed.
The fuse rating is also to be found on the
rating plate.
Always plug the mains plug into a correctly
●
installed shockproof socket.
Hide quick links:
Advertisement
Table of Contents
