Something Not Working; Fault Codes - Zanussi ZDF401 User Manual

Dishwasher zdf 401
Table of Contents

Advertisement

Something not working

The dishwasher will not start or stops during
operation. Certain problems are due to the lack
of simple maintenance or oversights, which can
be solved with the help of the indications de-
scribed in the chart, without calling out an
engineer.
Fault code and malfunction
The dishwasher does not fill with water.
• continuous flashing of the light of the running
programme
• 1 flash of the "End of programme" light
The dishwasher will not drain.
• continuous flashing of the light of the running
programme
• 2 flashes of the "End of programme" light
• continuous flashing of the light of the running
programme
• 3 flashes of the end of programme indicator
light
• The programme does not start.
Once these checks have been carried out;
close the dishwasher's door and switch on the
appliance. Press the button of the programme
that was running before the intervention of the
20
Switch off the dishwasher, open the door and
carry out the following suggested corrective ac-
tions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fit-
ting at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is bent or squashed.
Check the water drain hose connection.
• Anti-flood device is activated
Close the water tap and contact your local Service
Force Centre.
• The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the mains plug.
• The fuse has blown in the household fuse box.
Replace the fuse.
alarm. The programme will continue from the
point at which it was interrupted.
If the malfunction or fault code reappears con-
tact the Service Force Centre.

Advertisement

Table of Contents
loading

Table of Contents