Clear A Staple Jam In The Saddle Stitch Unit - Oce Saddle Finisher-AF2 User Manual

Clear a staple jam in the saddle stitch unit

Clear a staple jam in the saddle stitch unit
Introduction
Note:
This procedure is only required when the optional Saddle Finisher-AF2 is installed.
If a staple jam occurs in the saddle stitch unit of the stacker/stapler (Saddle Finisher-AF2),
the operator panel will display the location of the staple jam and a procedure to clear the
staple jam. Follow the procedure on the operator panel to clear the staple jam. The pro-
cedure below describes how to clear a staple jam in the saddle stitch unit of the stacker/sta-
pler.
Before you begin
First remove all output sheets from the booklet tray.
Warning:
Be careful when you handle optional units that are attached to the machine. When you
open the door or cover of an optional unit to replace a staple cartridge, discard the punch
waste, or clear paper jams or staple jams, prints may still be output if other optional units
are operating normally, and are not involved in the paper or staple jam removal procedure.
Note:
If a paper jam occurs at the same time as a staple jam, first remove the jammed paper,
then remove the jammed staples.
How to clear a staple jam in the saddle stitch unit
Clear a staple jam
Step
1
52 Chapter 4 - Troubleshooting
#
Action
Open the front door of the stack-
er/stapler.
Illustration