Clear A Paper Jam In The Top Cover Of The Stacker/Stapler - Oce Saddle Finisher-AF2 User Manual

Clear a paper jam in the top cover of the stacker/stapler

Introduction
If a paper jam occurs in the top cover of the stacker/stapler (Finisher-AF1/Saddle Finisher-
AF2), the operator panel will display the location of the paper jam and the procedure to
clear the paper jam. Follow the instructions on the operator panel to clear the paper jam.
The procedure below describes how to clear a paper jam in the top cover of the stacker/sta-
pler.
Warning:
When you remove jammed originals or paper, take care not to cut your hands on the
edges of the originals or paper.
Warning:
When you remove jammed originals or paper, take care not to cut your hands on the
inside of the machine. If you cannot remove the paper, contact Service or your local au-
thorized dealer.
Warning:
Be careful when you handle optional units that are attached to the machine. When you
open the door or cover of an optional unit to replace a staple cartridge, discard the punch
waste, or clear paper jams or staple jams, prints may still be output if other optional units
are operating normally, and are not involved in the paper or staple jam removal procedure.
Note:
If the inserter (Document Insertion Unit-F1) is attached to the stacker/stapler, the part
of the inserter may interfere with the stacker/stapler when you clear jams. Lift up the
inserter before you clear jams in the stacker/stapler.
Clear a paper jam in the top cover of the stacker/stapler
Chapter 4 - Troubleshooting 35