Operation; Section 4 Operation; Operator Control Panel - Baldor PC1100R Installation & Operating Manual

Section 4

Operation

Operator Control Panel

The Operator Control Panel is shown in Figure 4-1.
Pilot Lamp
Overload Lamp *
Oil Level Lamp
Auto Power Save *
(switch)
* Available only on PC1700RI.
MN2411
Figure 4-1 Operator Control Panel
OVER
LOAD
PILOT
LAMP
STOP
ENGINE SWITCH
Lamp (Green) is ON when generator is running properly.
Lamp (Red) is ON when generator is running and an overload condition exists.
If Overload Lamp is ON, Stop the generator and Start the generator again to resume
operation.
Lamp is on when engine oil level is less than a predetermined level. When the lamp
turns ON, the engine will stop automatically. If Oil Lamp is ON, replenish the engine oil
level and restart the engine.
OFF. Generator runs at full speed and produces full power. Use OFF for DC power.
ON. Generator idles during no load condition and automatically resumes full
speed when a load demand is present.
OFF ON
AUTO
POWER
SAVE
~ AC OUTPUT
AC
DC12V − 8.3A
RUN
BATTERY CHARGE ONLY
− +
−
ON OFF
CHOKE
AC Circuit Breaker
+
DC Circuit Breaker
Operation 4-1