Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Baldor PC1100R
Summary of Contents for Baldor PC1100R
- Page 1 PC1100R/PC1700RI Portable Generator Installation & Operating Manual 5/05 MN2411...
- Page 2 WARNING: CALIFORNIA PROPOSITION 65 WARNING: Engine exhaust from this product contains chemicals known to the state of California to cause cancer, birth defects and other reproductive harm. WARNING: CALIFORNIA PROPOSITION 65 WARNING: Battery posts, terminals and related accessories are known to the state of California to cause cancer, birth defects and other reproductive harm.
-
Page 3: Table Of Contents
Table of Contents Section 1 Product Safety Information ............... . Safety Notice . - Page 4 ii Table of Contents MN2411...
-
Page 5: Product Safety Information
Any person that installs or repairs this generator must have these specialized skills to ensure that this generating unit is safe to operate. Contact Baldor service department for repairs or any questions you may have about the safe installation and operation of this system. -
Page 6: Important Safety Instructions
Symbols This symbol is shown throughout the manual to indicate a connection to ground reference point. Indicates a potentially hazardous situation which, if not avoided, could result in injury or death. Indicates a potentially hazardous situation which, if not avoided, could result in injury or death. Precaution Statements Used In This Manual There are three classifications of precautionary statements used in this manual. - Page 7 Operation Warning Statements Continued WARNING: Some parts of this generator rotate during operation. Rotating parts can present extreme danger if clothing or body extremities are caught by the rotating part and can cause serious or fatal injury. Never touch a part of the generator until the engine has been stopped and all rotating parts are completely stopped.
- Page 8 WARNING: Installation and repair procedures requires specialized skills with electrical generating equipment and small engine systems. Any person that installs or performs repairs must have these specialized skills to ensure that the generator set is safe to operate. Contact Baldor for installation or repairs.
-
Page 9: Caution Statements
Warning Statements Continued Maintenance WARNING: Before cleaning, inspecting, repairing, refueling or performing any maintenance to the generator set, always be sure the engine has stopped and that all rotating parts have also stopped. After stopping, certain components are still extremely hot so be careful not to get burned. - Page 10 1-6 Product Safety Information MN2411...
-
Page 11: General Information
Baldor Generator repair facility, or to Baldor Generators’ Customer Service Department. Written notification of the alleged defect in addition to a description of the manner in which the Baldor generator is used, and the name, address and telephone number of the party requiring warranty service must be included. Baldor is not responsible for removal and shipment of the Baldor product to the service center or for the reinstallation of the Baldor product upon its return to the party requiring warranty service. - Page 12 2-2 General Information MN2411...
-
Page 13: Receiving & Installation
If the system is to be stored for several weeks before use, be sure that it is stored in a location that conforms to published storage temperature and humidity specifications. Lifting the Generator The generator weighs about 55 lbs dry. Use proper lift equipment and methods to avoid injury. Figure 3-1 PC17RI Portable Generator PC1100R PC1700RI AUTO OVER POWER... -
Page 14: Physical Location
Physical Location Your generator is portable to go where the work is. To be safe, several factors must be considered: Keep extension cords as short as possible. For effective cooling and maintenance, the generator should be mounted on a flat, smooth, non-flammable level surface. -
Page 15: Frame Ground Connection
Frame Ground Connection WARNING: Be sure the system is properly grounded before applying power. Do not apply AC power before you ensure that grounds are connected. Electrical shock can cause serious or fatal injury. NEC requires that the frame and exposed conductive surfaces (metal parts) be connected to an approved earth ground. -
Page 16: Use Of Electric Motor Loads
Use of Electric Motor Loads Electric motors require much more current (amperes) to start them than to keep them running. Some motors, particularly split−phase motors are very difficult to start and require 5 to 7 times more current to start them. Repulsion−induction type motors are the easiest to start and normally only require 2 to 3 times as much current to start them. -
Page 17: Operation
Section 4 Operation Operator Control Panel The Operator Control Panel is shown in Figure 4-1. Figure 4-1 Operator Control Panel AUTO OVER POWER LOAD SAVE PILOT LAMP ~ AC OUTPUT AC Circuit Breaker STOP DC12V − 8.3A BATTERY CHARGE ONLY −... - Page 18 Note: The nominal voltage produced by the generator at each receptacle is 120VAC. AC Circuit Breaker Protects the generators output windings from overload (only available on PC1100R). DC Circuit Breaker Provide overcurrent protection for the DC Output terminals. When tripped, the plunger will extend from the body of the breaker.
-
Page 19: Pre−Start Checks
Operator Control Panel Continued DC Circuit Breaker Provide overcurrent protection for the DC Output terminals. When tripped, the plunger will extend from the body of the breaker. Simply push the plunger in to reset the breaker. Note: If the breaker continues to trip, disconnect all loads and reset the breaker. If the breaker trips with all loads disconnected, turn off the generator and discontinue use until the generator is repaired. - Page 20 4-4 Operation MN2411...
-
Page 21: Troubleshooting And Maintenance
Section 5 Troubleshooting and Maintenance WARNING: Before cleaning, inspecting, repairing, refueling or performing any maintenance to the generator set, always be sure the engine has stopped and that all rotating parts have also stopped. After stopping, certain components are still extremely hot so be careful not to get burned. WARNING: Before servicing the generator set, be sure to disconnect the spark plug wires to prevent accidental engine rotation or starting. -
Page 22: Clean/Adjust Spark Plug
Note 1: Initial oil change should be performed after 20 hours of operation and every 100 hours thereafter. Dispose of used oil properly at recycling center. Note 2: Please consult with Baldor Service for the correct procedures to follow for these items. 5-2 Troubleshooting and Maintenance... -
Page 23: Voltage Variations
Voltage Variations This generator set must be run at its proper speed to obtain the correct electrical power at its output. All engines have a tendency to slow down when a load is applied to it. The engine governor is designed to hold the operating speed as nearly constant as possible. When the electrical load is increased, the engine is more heavily loaded and engine speed drops slightly. -
Page 24: Engine Oil
Service Service for your generator can be obtained from Baldor Generators. Please have the following information available prior to contacting the factory: The model number and serial number of the generator set. A complete and accurate description of the problem. - Page 25 Baldor District Offices UNITED STATES FAX: 586−978−9969 TEXAS CHINA MICHIGAN Continued HOUSTON SHANGHAI JIAHUA BUSINESS CENTER ARIZONA GAND RAPIDS 4647 PINE TIMBERS ROOM NO. A−8421 PHOENIX 668 3 MILE ROAD NW SUITE # 135 808 HONG QIAO ROAD 4211 S 43RD PLACE...
- Page 26 California to cause cancer, birth defects and other reproductive harm. BALDOR ELECTRIC COMPANY P.O. Box 2400 Ft. Smith, AR 72901- -2400 (479) 646- -4711 Fax (479) 648- -5792 © Baldor Electric Company Printed in USA MN2411 5/05...