Table of Contents
Advertisement
Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
5.
Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing nuts should be turned an equal
amount.
[ECS00592]
Drive track
More than
deflection
specified
Left adjusting
nut
Right adjust-
ing nut
6.
Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7.
Lower the snowmobile to the ground.
8.
Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
Periodic maintenance and adjustment
Less than
specified
Turn in
Turn out
Turn in
Turn out
1
2
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
ECS00350
NOTICE
Ride on fresh snow frequently. Operating
on ice or hard-packed snow will rapidly
wear the slide runners.
ESU12182
High-profile pattern drive track
FX10XT75/FX10M53S/FX10M62S
This snowmobile is originally equipped with a
high-profile pattern drive track with a lug
height of 38 mm (1.5 in.) or more specifically
for use in deep snow riding conditions.
Therefore, avoid prolonged operation on hard
surfaces such as ice, hard-packed snow, dirt,
etc., to extend the life of the track and slide
runners.
87
Advertisement
Table of Contents
