Yamaha Diversion 900 Owner's Manual page 77

CAUTION:
@
Do not push the brake pedal after
the wheel has been removed togeth-
er with the brake disc, otherwise the
brake pads will be forced shut.
@
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA00062
1. Splines
To install the rear wheel
1. Apply a light coating of lithium-
soap-based grease to the splines
of the final gear case and wheel
hub.
2. Install the wheel by inserting the
wheel axle, and then install the
axle nut.
3. Install the brake caliper by install-
ing the bolts.
NOTE:
@
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
@
4. Install the brake torque rod bolt,
@
Always use a new cotter pin.
@
5. Tighten the rear wheel axle pinch
EAU03411
6. Take the motorcycle off the cen-
7. Tighten the axle nut, wheel axle
6-34
nut and cotter pin at the brake cal-
iper bracket.
WARNING
bolt to the specified torque.
Tightening torque:
Rear wheel axle pinch bolt:
16 Nm (1.6 m·kg)
terstand so that the rear wheel is
on the ground.
pinch bolt, brake caliper bolts and
brake torque rod nut to the speci-
fied torques.
EW000124
6