Speedometer Unit - Yamaha Diversion 900 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
3
1. Left turn signal indicator light "
2. Fuel level warning light "
3. Neutral indicator light "
4. High beam indicator light "
5. Oil level warning light "
6. Right turn signal indicator light "
Neutral indicator light "
This indicator light comes on when the
transmission is in the neutral position.
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Oil level warning light "
This warning light comes on when the
engine oil level is low.
The electrical circuit of the warning light
can be checked according to the fol-
lowing procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Shift the transmission into the neu-
"
"
tral position or pull the clutch lever.
"
3. Push the start switch. If the warn-
"
ing light does not come on while
"
"
pushing the start switch, have a
Yamaha dealer check the electri-
EAU00061
"
cal circuit.
NOTE:
@
Even if the oil level is sufficient, the
warning light may flicker when riding on
EAU00063
"
a slope or during sudden acceleration
or deceleration, but this is not a mal-
function.
@
EAU03201
"
"
1. Tripmeter
2. Odometer
3. Tripmeter reset button

Speedometer unit

The speedometer unit is equipped with
a speedometer, an odometer and a
tripmeter. The speedometer shows
riding speed. The odometer shows the
total distance traveled. The tripmeter
shows the distance traveled since it
was last set to zero with the reset but-
ton. The tripmeter can be used to esti-
mate the distance that can be traveled
with a full tank of fuel. This information
will enable you to plan future fuel stops.
3-3
EAU00094