VTech VT 2961 Manual page 21

ANSWERING SYSTEM SETUP
ANSWER
MEMO ANSWER ON/OFF
TIME/SET SELECT MENU
MENU
DELETE
SPARE
CHARGING BATTERY NEW CALL
1 2 3
MAIL BOX
PLAY/STOP
REPEAT SKIP
VOLUME
MUTE INTERCOM
CONF HOLD FLASH
LINE 1 OFF LINE 2
MIC
3. Press any MAILBOX key to stop the recording.
4. Then OGM replays the message automatically, followed by a beep.
5. To review a recorded announce-ment, press MENU key until "Set Outgoing Message"
is announced. Press any MAILBOX key. The current greeting is played.
6. To delete a recorded announce-ment, press DELETE during OGM playback. You then
hear "Outgoing Message has been erased".
NOTE:
If your recording time is less than 2 seconds, your OGM will not be recorded, and the
default greeting will be used.
Set Security Code
The security code programmed into the Answering System is used to gain access to
MEMO ANSWER ON/OFF
TIME/SET SELECT
SPARE
CHARGING BATTERY NEW CALL
1 2
MAIL BOX
PLAY/STOP
REPEAT SKIP
MUTE INTERCOM
CONF HOLD FLASH
LINE 1 OFF LINE 2
MIC
Recording Your OGM
MENU
MEMO
1
Set Security Code
MENU
ANSWER
MENU
MENU
DELETE
TIME/SET
3
SELECT
VOLUME
TIME/SET
NOTE:
In Announce Only mode, your
outgoing announcement is repeated
before hanging up.
Recording / Playing / Deleting
the Outgoing Messages
(OGM)
1. Press MENU key until the
3
2
MAIL BOX
desired
PLAY/STOP
Message) is announced.
2. Press MEMO. "Now recording",
is announced, followed by a beep.
Speak towards the front of the
Answering System (max. length:
90 seconds).
functions from remote locations.
The security code default setting is 19.
1. Press MENU unit you hear "Set security
code."
2. Press TIME/SET to hear the current
security code.
3. Press SELECT briefly to increase the
security code by 1. Or, hold SELECT
continuously to increase the code by
multiples of 10.
4. Press TIME/SET to confirm your choice
and you will hear the announcement of the
security code.
21
item (Set Outgoing