Table of Contents
Advertisement
BASIC OPERATIONS
AREA CODE PROGRAMMING
To benefit from all the Caller ID features of your telephone,
you must enter your home area code.
If you live in an area where you dial calls within your own area
code by dialing 7 digits (no area code), follow these steps
(with the Handset OFF ):
1. Press PROG.
2. Press
until AREA is blinking.
3. Press SELECT.
4. HOME should be blinking. If not, press
blinks.
5. Press SELECT. ENTER AREA CODE is displayed.
6. Enter your own home area code.
7. Press SELECT.
ALTERNATE METHOD
If you live in an area where all local calls require 10 digits (area code plus phone number,
without dialing "1" first:)
1. Press PROG.
2. Press
until AREA is blinking.
3. Press SELECT.
4. HOME should be blinking. If not, press
5. Press SELECT. ENTER AREA CODE is displayed.
6. Enter 000.
7. Press SELECT and continue below.
You may program up to 5 local area codes. An area code is "local" if you do not dial "1" when
you make calls to that area code. In other words, you make calls to "local" area codes by
dialing 10 digits (area code plus phone number) without a preceding "1". This might include
your own area code
1. Press PROG.
2. Press
until AREA is blinking.
3. Press SELECT.
4. Press
until LOCAL is blinking.
Press SELECT.
5. Press
until the desired location is blinking (#1.....#5).
6. Press SELECT . ENTER AREA CODE is displayed.
7. Enter a "local" area code.
8. Press SELECT.
9. Press OFF when finished.
NOTE: To replace or edit an existing area code, use the
existing digits, and enter the desired area code. Press SELECT when done.
until it
until it blinks.
10
SELECT
LINE 1
OFF
LINE 2
2
3
1
ABC
DEF
5
4
6
GHI
JKL
MNO
8
7
9
PQRS
TUV
WXYZ
0
TONE
OPER
REDIAL/PAUSE
HOLD
PROG
FLASH
CONF
INTERCOM
key to delete the
Advertisement
Table of Contents
