Toshiba TOSVERT VF-A7 Instruction Manual page 41

Input /
Terminal
output
symbol
Multifunction programmable analog output. Factory
default setting: Operation frequency command.
FM
Output
Connect
7.5Vdc(10Vdc)-1mA full-scale voltmeter.
Multifunction programmable analog output. Factory
default setting: Output current. Connect a 1mAdc
AM
Output
full-scale ammeter or a 7.5Vdc(10Vdc)-1mA full-
scale voltmeter.
Multifunction open collector output. This terminal
FP outputs pulses at 1.00 kHz to 43.20 kHz. Factory
Output
default setting: 3.84kHz.
Common
CC Common terminal of the control circuit.
to I/O
24Vdc power output (power for control of the
P24
Output
inverter).
Multifunction programmable open collector output.
OUT1 The terminal has been set by default so as to detect
and output low-speed signal output frequencies.
Output Multifunction programmable open collector output.
The terminal has been set by default so as to detect
OUT2
and outputs signals indicating the completion of
acceleration/ deceleration.
Relay contact output.
A (cos
FLA
0.4). Used to detect the activation of the inverter's
FLB
protective function. If the protective function is
Output
activated, FLA-FLC circuit is closed, while FLB-FLC
FLC
circuit is opened .
Function
a 1mAdc full-scale
Contact rating: 250 Vac = -2
= 1), 30 Vdc-1 A and 250 Vac-1A (cos
Electrical
specification
1mA full-scale dc
ammeter
ammeter or a
7.5Vdc-1mA full-
scale dc voltmeter
1mA full-scale dc
ammeter
7.5Vdc-1mA full-
scale dc voltmeter
Max. 50 mA
24V
Open
output:
24Vdc-50mA
*Sink logic/
source logic
switchable
250Vac-2A
=
30Vdc-1A
:resistor load
250Vac-1A
:cos
B-9
Inverter internal
circuit
or
or
-100mA
DC
collector
=0.4