Parameter setting
Title
Selection of power running
torque limit #1
Power running torque limit #1
Selection of regenerative
torque limit #1
Regenerative torque limit #1
With these parameters, you can set 4 patterns of positive torque limits and 4 patterns of
negative torque limits. Refer to 7.2 for the setting for switching from the terminal board.
Power running torque limit #1
Power running torque limit #2
Power running torque limit #3
Power running torque limit #4
Note) If the value set with (stall prevention level) is smaller than the torque limit, then the value set
with acts as the torque limit.
b) Limiting the torque with external signals
Regenerative
Reverse
Power running
The torque limits can be changed arbitrarily by means of external signals.
[External signals]
Voltage signals
Current signals
Function
: VI(voltage) / II(current)
: RR(volume / voltage)
: RX(voltage)
: RX2(voltage)(optional)
:
[%], : Invalid
: VI(voltage) / II(current)
: RR(volume / voltage)
: RX(voltage)
: RX2(voltage)(optional)
:
[%], : Invalid
Regenerative torque limit #1
Regenerative torque limit #2
Regenerative torque limit #3
Regenerative torque limit #4
Power running
Regenerative
RR-CC
0 10V
RX-CC
0
10V
VI-CC
0 10V
II-CC
4(0) 20mA
F-46
Adjustment range
250% torque
Forward
250% torque
,
Default setting