Input1 Trim; Int Mic Set; Input1 Wind; Input2 Trim - Sony NXCAM NEX-EA50UH Operating Manual

INT MIC SET

x INT MIC SENS
You can set the recording sensitivity when
using the internal microphone.
B NORMAL
Sensitivity generally used for professional-
use devices
HIGH
Sensitivity generally used for consumer-
use devices
x INT MIC WIND
Diminish low tone in input sound with the
internal microphone, and reduce wind
noise.
B OFF
Disables wind noise reduction.
ON ( )
Enables wind noise reduction.
XLR SET
x XLR AGC LINK
You can select either linked or separate
AGC (Auto Gain Control) of CH1 and CH2
when using an external microphone.
B SEPARATE
Separately applies the AGC for CH1/CH2.
Sound inputs from CH1/CH2 will be
recorded as separate sound.
LINKED ( )
Applies the AGC of CH1 linked with that
of CH2. Sound inputs from CH1/CH2 will
be recorded as a set of sound such as stereo
sound. appears on the status check
screen.
b Notes
• This function is available when the CH1 and
CH2 switches are both set to AUTO and the
INPUT 1 and INPUT 2 switches are both set to
MIC or both set to LINE (p. 51).

INPUT1 TRIM

x
You can adjust the input signal level from
INPUT 1.
-18dB, -12dB, -6dB, B0dB, +6dB,
+12dB
b Notes
• The setting is not effective when you set the
INPUT 1 switch to LINE.

INPUT1 WIND

x
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT 1 switch to LINE.
x

INPUT2 TRIM

x

INPUT2 WIND

You can set INPUT 2 in the same way as
INPUT 1.
z Tips
• -48 dBu is set as 0dB in your camcorder.
• Set INPUT TRIM to [0dB] for the supplied
microphone.
• The INPUT TRIM function adjusts the input
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
• Distortion when recording loud sound may
result at the input point, or at the recording
point. If it is distorted at the input point, adjust
the sound using the INPUT TRIM function. If it
is distorted at the recording point, lower the total
volume level manually.
• If you set INPUT TRIM too far to the minus
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
• Test the effect of [XLR SET] according to the
microphone used or the sound field of the
recording site before actual recording.
93