Acquiring Location Information (Gps) - Sony NXCAM NEX-EA50UH Operating Manual

To copy the picture profile setting to
another picture profile number
See page 53 for the location of the buttons.
1 Press the PICTURE PROFILE button
A.
2 Select the picture profile number that
you want to copy from with the SEL/
PUSH EXEC dial B, then press the
dial.
3 Select [SETTING] t [COPY] with the
SEL/PUSH EXEC dial B, then press
the dial.
4 Select the number of the picture profile
that you want to copy to with the SEL/
PUSH EXEC dial B, then press the
dial.
5 Select [YES] t [
[OK] with the SEL/PUSH EXEC dial
B.
To reset the picture profile settings
You can reset the picture profile settings by
each picture profile number. You cannot
reset all picture profile settings at once.
See page 53 for the location of the buttons.
1 Press the PICTURE PROFILE button
A.
2 Select the picture profile number that
you want to reset with the SEL/PUSH
EXEC dial B, then press the dial.
3 Select [SETTING] t [RESET] t
[YES] t [ RETURN] t [OK]
with the SEL/PUSH EXEC dial B.
RETURN] t
Acquiring location information
(GPS)
1
Press the MENU button during
standby.
2
Select (OTHERS) t [GPS
SETTING] t [ON] (default
setting) with the SEL/PUSH EXEC
dial.
appears, and your camcorder
starts trying to triangulate. When your
camcorder triangulates successfully, it
will record the location information at
the time movies were recorded.
b Notes
• The indicator changes according to the strength
of GPS signal reception.
Tri-
GPS
angulating
indicators
status
Function No
off indicator
Difficult
Searching
Tri-
angulating
GPS reception status
[GPS SETTING] is
set to [OFF], or the
GPS receiver is not
functioning normally.
The camcorder
cannot find a GPS
signal, therefore, it
cannot triangulate.
Use the camcorder in
an open area.
The camcorder is
searching the GPS
signal. It may take
several minutes until
the camcorder
triangulates.
The camcorder is
receiving a weak GPS
signal.
Continued ,
59