Lan Settings - Siemens Gigaset WLAN Operating Instructions Manual

LAN settings

For Access point mode.
In the next step, you will see the LAN screen for the basic setup of your local network.
ì
In IP address type specify whether the Gigaset WLAN Repeater should obtain its IP
address automatically from an external DHCP server in the network or not.
If you want to use a static IP address for your Gigaset WLAN Repeater (factory setting
for the IP address is 192.168.2.254), select the option Static and enter the IP address
and subnet mask in the boxes underneath. Make sure that the IP address you assign
complies with the conventions for private IP addresses described on page 31.
Please remember:
If you want to use several Gigaset WLAN Repeater in the same network, make sure
you assign different IP addresses to each of them. Use an address block that is
within the selected subnet but not in the address block of the addresses automat-
ically assigned by the DHCP server in your network.
ì
Normally you do not have to change the option for the IP address type. If your
Gigaset WLAN Repeater nevertheless obtains its IP address automatically from a
DHCP server in your network, please select Obtained automatically.
Basic setup
53