Assembling The Piano - Roland RP301R Owner's Manual

2. Assembling the Piano

1.
Align the screws on the bottom of the piano (one each at
left and right) with the metal brackets on the side boards,
and while keeping the front of the piano slightly raised,
pull it toward yourself to engage the screws in the metal
brackets.
* When handling the piano, fi rmly grasp it. Be careful, so you do not get
your fi ngers pinched.
2.
Fasten the piano to the stand with the screw
mm).
Screw D
3.
Loosen the music rest screws slightly (2–3 mm), insert the
music rest brackets between the screws and the body of the
piano, and turn the screws to secure the music rest while
using one hand to support the music rest.
When attaching the music rest, make sure that it is fi rmly inserted all
the way toward the back, and use your hand to support the music rest
so that it does not fall. Also take care not to pinch your hand.
* Do not apply excessive force to the music rest.
* If you need to remove the music rest, loosen the screws while using
one hand to support the music rest. Detach the music rest, and then
fi rmly retighten the screws.
4.
Connect the AC adaptor to the DC In jack on the back of the
piano, and connect the pedal cord to the Pedal connector.
As needed, use the coated clip on the bottom of the piano
to fasten the power cord and the pedal cord.
(5 x 20
D
Please don't get your
fi ngers pinched.
Screw D
Pull the piano toward yourself while
keeping the front slightly raised.
Coated clip
5.
Use screws (4 x 16 mm) to fasten the headphone hook.
E
6.
Connect the supplied AC adaptor and power cord.
Place the AC adaptor so the side with the indicator faces upwards and
the side with textual information faces downwards. The indicator will
light when you plug the AC adaptor into an AC outlet.
7.
Adjust the Adjuster.
Turn the adjuster to lower it until the adjuster is in fi rm contact with
the fl oor. In particular, when you've placed the piano on carpet, you
must turn the adjuster until it is pressing fi rmly against the fl oor.
* The pedal may be damaged if there is a gap between the adjuster and
the fl oor.
About ground terminal
Depending on the circumstances of a particular setup, you may experience a
discomforting sensation, or perceive that the surface feels gritty to the touch
when you touch this device. This is due to an infi nitesimal electrical charge,
which is absolutely harmless. However, if you are concerned about this,
connect the ground terminal (see fi gure) with an external ground. When the
unit is grounded, a slight hum may occur, depending on the particulars of your
installation. If you are unsure of the connection method, contact the nearest
Roland Service Center, or an authorized Roland distributor, as listed on the
"Information" page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fi re or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of
lightning)
When moving the unit
If you need to move the unit, you must fi rst detach the music rest, close the
keyboard cover, disconnect the AC adaptor, and raise the stand adjuster. With at
least one other person helping you, lift the unit horizontally and carry it, taking
care not to pinch your hands or drop the unit on your feet.
E
Screw (2 pcs.)
Power cord
To AC outlet
Adjuster
39 39