Maintenance - Ryobi ESS2414K Owner's Operating Manual

OPERATION
ORBITAL MOTION (Fig. 2)
Orbital motion is ideal for fast cutting action when removing
old finishes, smoothing rough wood, cutting stock down to
required dimensions, or for finishing surfaces to be painted.
The sandpaper moves in tiny circles at a very high speed,
allowing the sander to move easily.
WARNING
Collected sanding dust from sanding surface
coatings such as polyurethanes, linseed oil, etc.
can self-ignite in your sander dust bag or
elsewhere and cause fire. To reduce the risk of fire
always empty your dust bag frequently while
sanding and never store or leave a sander without
totally emptying its dust bag. Also follow the
recommendations of the coatings manufacturers.
USING THE DUST BAG ASSEMBLY
The dust bag assembly provides a dust collection
system for the sander. Sanding dust is drawn up
through the holes of the sanding disc and collected
in the dust bag during sanding.
TO ATTACH THE DUST BAG ASSEMBLY (Fig. 3)
Follow these directions to attach the dust bag
assembly.
Unplug the sander.
■
WARNING
Failure to unplug the tool could result in
accidental starting causing possible serious
injury.
Slide the dust bag assembly onto the blower exhaust
■
on the sander using a slight twisting motion.
TO EMPTY THE DUST BAG ASSEMBLY (Fig. 4)
For more efficient operation, empty the dust bag when
it is no more than half full. This will permit the air to
flow through the bag better. Always empty and clean
the dust bag thoroughly upon completion of a sanding
operation and before placing the sander in storage.
TO EMPTY DUST BAG
Unplug your sander.
■
WARNING
Failure to unplug your sander could result in
accidental starting causing possible serious
personal injury.
Remove the dust bag assembly from the sander.
■
Remove the dust bag from the frame.
■
Shake out the dust.
■
Replace the dust bag on the frame.
■
Replace the dust bag assembly on the sander.
■
HOOK AND LOOP POWER CORD WRAP (Fig. 7)
This tool is fitted with a hook and loop power cord
wrap, this is designed to keep the power cord
wrapped up when the tool is not in use and for easier
storage of the tool, loop the power cord several times
(depending on the length) and loop the wrap around
the power cord until secure.
Livetool Indicator
This tool features a Livetool Indicator
illuminates as soon as the tool is connected to the
power supply. This warns the user that the tool is
connected to live power and will operate when the
switch is pressed.

MAINTENANCE

After use, check the tool to make sure that it is in
good condition. It is recommended that you take
this tool to a RYOBI Authorized Service Centre for
a thorough cleaning and Iubrication at least once
a year.
Don't make any adjustments while the motor is in
motion.
Always disconnect the power cord from the power
supply before changing removable or consumable
parts(blade),before lubricating or working on the
unit.
If the supply cord is damaged, it shall be
replaced by the manufacturer or its service
centre or similar qualified person in order to
avoid a hazard.
WARNING
To ensure safety and reliability, all repairs should
be performed by an AUTHORIZED SERVICE
CENTRE or other QUALIFIED SERVICE
ORGANIZATION.
L'ENVIRONNEMENT
4
TM
TM
(8) which