Specification - Ryobi ESS2414K Owner's Operating Manual

GENERAL SAFETY RULES
Disconnect the plug from the power source
■
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting
the power tool accidentally.
Store idle power tools out of the reach of children
■
and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool. Power tools are dangerous in the hands
of untrained users.
Maintain power tools. Check for misalignment or
■
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
■
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc.,
■
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from intended could result
in a hazardous situation.
SERVICE
Have your power tool serviced by a qualified
■
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
SPECIFIC SAFETY INSTRUCTIONS FOR
SANDERS
Always wear safety goggles and a dust mask
when sanding, especially sanding over-head.
The machine is not suitable for wet sanding.
■
Do not use sanding paper larger than needed.
■
Extra paper extending beyond the sanding pad can
also cause serious lacerations.
The dust bag shall be equipped with the tool.
■
It shall be emptied frequently. To connect dust bag,
insert the adapter of dust bag to the dust-collection
opening on the rear end of the sander.
WARNING
Do not throw sanding dust on an open fire
because materials in fine particle form may be
explosive.
WARNING
A suitable breathing respirator must be worn
while sanding lead paint, some woods and metal
to avoid breathing the harmful/toxic dust or air.

SPECIFICATION

Input
Wattage
No load speed
Orbital diameter
Net weight
APPLICATIONS
Use only for the purposes listed below:
Sanding on wood surfaces.
■
Removing rust from and sanding steel surfaces.
■
Sanding plastics.
■
DESCRIPTION
1. Switch
2. Paper clamp
3. Cushion
4. Tab
5. Lever
6. Dust bag frame
FEATURES
Your sander is suitable for sanding with coarse, medium,
and fine grit sandpaper. It will produce a fine scratch free
finish when used to sand with the grain on wood surfaces.
It has been designed so that flush corner sanding on
three sides of the sander is possible.
Your sander has a comfortable palm grip handle that
provides maximum one-hand comfort, and reduces
operator fatigue during continuous sanding operations.
Your sander also has a built in dust collection that collects
dust through punched holes in the sandpaper and
cushion (Fig. 5).
Before attempting to use your sander, familiarize
yourself with all operating features and safety
requirements.
SWITCH (1)
This tool is equipped with a simple switch control. To turn
the sander "ON", slide the switch to the left.
Slide the switch to the right to turn the sander "OFF".
WARNING
Do not allow familiarity with your sander to make
you careless. Remember, a careless fraction of a
second is sufficient to inflict severe injury.
2
240 V ~ 50 Hz
240 W
-
1
14000 min
1.6 mm
1.56 kg
7. Dust bag
TM
8. Livetool Indicator
9. Paper punch
10. Base
11. Non-adhesive sandpaper