What To Do If - Zanussi ZKT 652 DBV Installation And Operating Instructions Manual

What to do if ...

Problem
The appliance cannot be switched
on or is not operating
The cooking zones automatically
reduce the cooking level to
The residual heat indicator is not
displaying anything
acoustic signal sounds, appliance
switches off
Acoustic signal sounds and appli-
ance switches itself on and after 10
seconds off again
Display is switching between two
heat settings
flashes
is lit
and number are displayed
36
Possible cause
More than 10 seconds have passed
since the appliance was switched
on
The lock is switched on
The child safety device is switched
on
Several sensor fields were touched
at the same time
Safety cut-out has been triggered
The sensor fields are partly covered
by a damp cloth or with liquid
The cooking zone was only on for a
short time and is therefore not hot
One or more sensor fields have
been covered for longer than 10
seconds
The On/Off sensor field has been
covered up, e.g. by a cloth
Power management is reducing the
power of this cooking zone
Unsuitable cookware
No cookware on the cooking zone
The diameter of the bottom of the
cookware is too small for the cook-
ing zone
Overheating protection for the
cooking zone has been triggered
Safety cut-out has been triggered
Electronics fault
Remedy
Switch the appliance on again.
Switch off the lock (See the section
"Locking/unlocking the control
panel")
Deactivate child safety device (See
the section "Child safety device")
Only touch one sensor field
Remove any objects (pan, cloths,
etc.) that are lying on the control
panel. Switch the appliance on
again
Remove the cloth or the liquid.
Reset the cooking level required.
If the cooking zone is supposed to
be hot, call the Customer Service
Department.
Uncover sensor field
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on again
Switch off the cooking zone.
Switch the cooking zone on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's
wiring system)
If after switching on again,
played again, call the customer
service department
is dis-