Yamaha MOTIF ES Owner's Manual page 206

Voice Edit mode Plug-in Voice Edit
FMod (Filter Modulation Depth)
AMod
(Amplitude Modulation Depth)
[SF4] AC (Assignable Control)
Src (Source)
Filter
PMod (Pitch Modulation Depth)
FMod (Filter Modulation Depth)
AMod
(Amplitude Modulation Depth)
[F6] EFFECT
Same as in Normal Voice Common Edit. See page 194.
Please note that the EL: OUT settings are not available in the [SF1] CONNECT display and the parallel setting (Insertion Connection) is not available in the [SF1]
CONNECT display.
Element Edit
[F1] OSC (Oscillator)
[SF1] WAVE
Bank
Number
[SF5] OTHER
VelocityDepth
VelocityOffset
NoteShift
206
Owner's Manual
Element Edit
Determines the depth of control that keyboard aftertouch has over filter cutoff modulation. The higher the setting, the
greater the depth of control.
Settings: 0 ~ 127
Determines the depth of control that keyboard aftertouch has over amplitude modulation. The higher the setting, the
greater the depth of control.
Settings: 0 ~ 127
From this display you can assign MIDI Control Change numbers (as Src) and determine the degree to which
the assigned controllers affect the filter and the modulation effects (pitch, filter and amplitude).
Determines the MIDI Control Change number used to control the filter, PMod, FMod, and AMod.
Settings: 0 ~ 95
Determines the depth of control the Control Change numbers (set in the Src parameter above) have over the filter
cutoff frequency.
Settings: -64 ~ 0 ~ +63
Determines the depth of control the Control Change messages (set in the Src parameter above) have over pitch
modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
Determines the depth of control the Control Change messages (set in the Src parameter above) have over filter
cutoff modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
Determines the depth of control the Control Change messages (set in the Src parameter above) have over amplitude
modulation. The larger the setting, the greater the depth of control.
Settings: 0 ~ 127
[VOICE] Plug-in Voice selection
From this display you can select the desired Board Voice used for the Element of the Plug-in voice. Keep in mind that
a Plug-in voice only has one Element.
Determines the Board Voice Bank.
Settings: These depend on the particular Plug-in board; refer to the relevant owner's manual for details.
Determines the Board Voice Number.
Settings: These depend on the particular Plug-in board; refer to the relevant owner's manual for details.
Determines the velocity sensitivity of the Plug-in Voice. For higher values, the harder you play the keyboard, the
louder the voice becomes.
Settings: 0 ~ 127
This lets you specify an offset value for Velocity Depth (above). In other words, you can increase the relative velocity
(or level) of the voice by a set amount – so that all the notes you play have the added velocity.
Settings: 0 ~ 127
Determines the transpose setting for the Plug-in voice, or the amount (in semitones) by which the pitch is raised or
lowered. The pitch range is two octaves, up or down.
Settings: -24 ~ 0 ~ +24
[EDIT] Element selection