Yamaha XT660R Service Manual page 63

1 Front turn signal light lead (right)
2 Meter assembly lead
3 Auxiliary light lead
4 Front turn signal light lead (left)
5 Headlight lead
6 Sub-wire harness
CABLE ROUTING
È Fasten the sub-wire harness and meter assem-
bly lead with a plastic band. Fasten the sub-wire
harness at the white tape. Face the end of the
plastic band forward.
É Make sure that there is no slack in the meter
assembly lead between the meter assembly and
the plastic band. The rubber boot on the meter
assembly can be bent as shown.
Ê Place the slack of the left and right front turn sig-
nal light leads between the headlight assembly
and front cowling assembly.
2 - 37
SPEC