Installing The Steering Head - Yamaha XT660R Service Manual

STEERING HEAD
3. Replace:
• bearings
• bearing races
M MMM M MMM M M MMM
a. Remove the bearing races from the steering
head pipe with a long rod 1 and hammer.
b. Remove the bearing race from the lower
bracket with a floor chisel 2 and hammer.
c. Install a new dust seal and new bearing
races.
CAUTION:
_
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
_
• Always replace the bearings and bearing
races as a set.
• Whenever the steering head is disassem-
bled, replace the dust seal.
L LLL L LLL L L LLL
4. Check:
• upper bracket
• lower bracket
(along with the steering stem)
Bends/cracks/damage → Replace.
EAS00683

INSTALLING THE STEERING HEAD

1. Lubricate:
• upper bearing
• lower bearing
• bearing races
Recommended lubricant
Lithium-soap-based grease
2. Install:
• lower ring nut 1
• rubber washer 2
• upper ring nut 3
• lock washer 4
Refer to "CHECKING THE STEERING
HEAD" in chapter 3.
4 - 72
CHAS
M M MMM M M MMM M
L L LLL L L LLL L
M MMM M MMM
L LLL L LLL