Radio Operation - Sharp CD-C491H Operation Manual

RADIO OPERATION

TUNER TUNING
(BAND) (
ON/
STAND-BY
Tuning
(Main unit operation)
)
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button.
3
Press the TUNER (BAND) button to select the desired
frequency band. (FM ST, FM, MW or LW)
4
Press the TUNING (
sired station.
Manual tuning:
Press the TUNING (
quired to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING (
than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
If a weak station signal is found during auto scan tuning,
the station will skipped.
To stop the auto tuning, press the TUNING (X or W) button
again.
When an RDS (Radio Data System) station is tuned in,
the RDS indicator will light first, and then the frequency
will be displayed. Finally, the station name will appear.
5
To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display
lights up.
j
"
6
If the FM reception is weak, press the TUNER (BAND)
button so that the "ST" indicator goes out.
Although the reception changes to monaural, the sound
becomes clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
The last station tuned in will be recalled, even after chang-
ing the tuning band or the function, or after switching the
unit to the stand-by mode.
17
CD-C491H(SUK) TINSE0229AWZZ
X W
or ) button to tune into the de-
X W
or ) button as many times as re-
X W
or ) button is pressed for more
" will appear when an FM broadcast is in stereo.