Sharp CD-C491H Operation Manual page 19

(Continued)
TUNER
(BAND)
MEMORY
Jog dial
TUNER
(BAND)
Preset tuning
You can store up to 40 stations in memory (40 stations con-
sisting of any combination of FM, MW and LW stations you
like) and recall them at the push of a button.
To enter stations into memory:
1
Perform steps 1 - 6 of the "Tuning" section.
2
Press the MEMORY button.
3
Within 30 seconds, turn the jog dial until the preset chan-
nel number flashes in the display.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in the selected station preset number memory.
PRESET
If the "MEMORY" and preset number indicators go out
before the station is memorised, repeat the operation from
step 2.
5
Repeat steps 1 - 4 to set other preset stations, or to
change a preset station.
To recall a memorised station:
W
Turn the jog dial on the main unit or press the PRESET (
or
to select the desired station.
The contents (preset channel number, frequency and fre-
quency band) which have been stored in memory will ap-
pear in the display in numerical order, irrespective of the
frequency bands.
Note:
When searching for a memorised station, do not press the
PRESET button for more than 0.5 seconds.
When the PRESET button is pressed for more than 0.5 sec-
onds, the unit will enter the preset memory scan mode.
Backup function:
The backup function protects all station presets for a few
hours should there be a power failure or the AC power lead
is removed from the AC socket.
Preset memory scan
(Remote control operation)
The stations saved in the preset memory can be scanned
automatically.
PRESET
1
W
To scan the preset stations, press the PRESET (
The station preset number flashes and programmed sta-
tions are sequentially received for 5 seconds each.
2
Press the PRESET (
memory scan at the desired station.
Note:
When the preset memory does not have any stations stored
in it, the preset memory scan will not function.
18
CD-C491H(SUK) TINSE0229AWZZ
) button on the remote control for less than 0.5 seconds
) button for more than 0.5 seconds.
X W
or ) button again to stop the
X
X
or