Sharp CD-C491H Operation Manual page 8

<P=007>
(Continued)
32 mm (1-1/4")
2
1
8-9 mm (3/8")
3.2 mm (1/8")
5 mm (3/16")
Min. 22 mm (7/8")
3
Wall mounting screw
Wall surface
4
Wall surface
To mount the surround speakers on the wall
The design of the surround speakers allows them to be hung on
the wall.
Be sure to use the type and size of screw that is shown to the
left.
1
Make a hole in the wall using a drill.
2
Drive a wall mount plug into the hole using a hammer. Drive
the wall mount plug in until it is flush with the wall surface.
3
Drive one screw into the wall mount plug for each speaker
as shown in the illustration.
Drive the screws, so there is about a 5 mm (3/16") space
between the wall and the head of the screw.
9 mm (3/8")
4
Mount the surround speaker on the wall so that the screw
head is inserted into the slot on the surround speaker.
Removing the speaker grilles on the front
speakers
1
Remove the lower part of the speaker grille first.
2
2
Remove the upper part of the speaker grille.
Note:
The speaker grilles on the other speakers cannot be removed.
Caution:
1
When the speaker grilles are removed, the speaker diaphragm
will be exposed. Make sure nothing comes into contact with the
diaphragm in the speakers.
Attaching the speaker grilles on the front
speakers
Align the four posts on the speaker grille with the holes in the
speaker.
Push gently on the grille with the palm of your hand to secure
it.
7
CD-C491H(SUK) TINSE0229AWZZ