Warning Messages - Barco NH-12 User Manual

7.11.4.2 Warning messages

What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message
NO SIGNAL
Lamp error icon
Lamp runtime warning
Lamp runtime exceeded
Desktop resolution not valid
Wait box
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
How to enable/disable Warning Messages?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the Service menu
4. Use ↑ or ↓ to select Operation options
5. Press → to pull down the Operation Options menu
6. Use ↑ of ↓ to select Warning Messages
7. Press → to pull down the Warning Messages menu
8. Use ↑ or ↓ to select On or Off
9. Press ENTER to confirm
Image 7-196
A white bullet shows the active setting
R59770121 NH-12 04/05/2011
Sim 5W Galaxy NH-12
Galaxy NW-12
Galaxy NW-7
x
x
x
x
x
Description
x
In case no incoming Sync is detected
In case of an actual lamp or LPS problem
x
Max lamp runtime almost reached
x
Max lamp runtime exceeded
x
Desktop input signal resolution is out of
specification.
x
An hourglass icon that is displayed during
processing
7. Advanced
157