Preferences; Language Setting; Automatic Startup - Barco NH-12 User Manual

5.8

Preferences

Overview
•

Language setting

•

Automatic startup

• Change password
5.8.1 Language setting
How to change the Language ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Language
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired language
Image 5-18
7. Press ENTER
The language is adapted and a bullet shows the active selection.
5.8.2 Automatic startup
What can be done ?
The automatic startup allows to bypass the standby state i.e. start up without going in standby state after switching on the projector.
This means that the automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing
through the standby state, by recovering the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons.
C
AUTION
precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
Unless it is required, it is advised to leave this setting OFF.
R59770121 NH-12 04/05/2011
:
If the Automatic startup function is enabled one must be aware of the fact that it involves safety
5. Setup
45