Autoimage Setup - Barco NH-12 User Manual

7. Advanced
The soft edge dialog box will be displayed.
8. Uncheck all the edges
9. Adjust the soft edge as desired (same procedure as above)
10.Press BACK to return to the Display setup menu.
7.9.8

AutoImage Setup

What can be done ?
AutoImage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the display.
AutoImage can adapt the image based on following data :
• Total pixels/ lines
• Start pixel/lines
• Phase
• Contrast/brightness levels
AutoImage works only for data signals.
To launch Autoimage, see AutoImage in the Image files menu
How to set up AutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select AutoImage setup
Image 7-173
5. Press ENTER
A dialog box is displayed.
Image 7-174
148 R59770121 NH-12 04/05/2011