Setting Up The Handset For Use - Siemens Gigaset SL37H User Manual

First steps

Setting up the handset for use

The display is protected
by a plastic film.
Please remove the
protective film!
Fitting the battery pack
Warning:
Only use the rechargeable Gigaset Communi-
cations GmbH * original battery pack
(page 30)! Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
¤
With the pins to the front, insert the
battery pack into the cavity at an angle
from the left.
¤
Then press it into the housing from
above until the bracket on the side of
the battery back snaps securely into the
housing.
Please note:
To remove the battery pack, you must first
press the bracket on the side.
6
Closing the battery cover
¤
Align the battery cover parallel to the
casing and press down until it clicks
into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Hold the device with the keypad facing
the palm of your hand.
¤
Place the thumb of your other hand on
the loudspeaker (a) and use the index
finger of the same hand to press the
groove at the top of the handset (b).
¤
Lift the cover.
a
b