Assembly & Installation - Harman Stove Company P68 Installation & Operating Manual

Fig. 1
Shipping Bolts
Note: These same holes
are used for securing the
stove in mobile home
installation.
Rear Cover
1. Remove wood handle ( P.N. 4-30-00123 ), 6mm
spring washer ( P.N. 3-31-08558 ) and socket head
cap screw ¼-20 x 2-1/4" ( P.N. 3-30-3025202252 )
from hardware pack.
Assembly and Installation
Panels
Door Handle Installation
Unpacking
The P68 is bolted (1/4 x 1" hex head bolts) to the
skid to prevent movement during shipping.
To free the stove from the skid you must remove
the hold-down bolts in the rear of the pedestal base.
Installing rear cover panels
The rear cover panels are removed from the stove
to make it easier to get at the hold-down bolts.
The rear cover panels are packed inside the hopper
and should be installed on the stove as shown. It
is recommended that the rear covers are installed
after the unit is in place and the vent pipe is
installed.
Firebrick
Install the firebrick vertically on the angle bracket
above the burnpot.
Flame Guide
Install the cast iron flame guide on top of the burn
pot. Make sure that the flame guide is fully seated
on the vertical sides of the burn pot and that the
back of the guide rests against the body of the
stove.
INSTALL EXHAUST VENT AT CLEARANCES
SPECIFIED BY THE MANUFACTURER. Most
pellet pipes require a minimum of 3" of clearance
to combustible materials.
Fig. 2
2. Install spring washer and wood handle onto socket
head cap screw as shown in fig. 2 and thread onto
latch on front door.
3. Tighten using a 3/16" hex key wrench.
Wood Handle
3-40-00123
8mm Spring Washer
3-31-08558
SHCS 1/4-20 x 2-1/4
3-30-3025202252
P68 Pellet Stove
5