Input Label; Position; Wss (Wide Screen Signalling); Antenna Supply Voltage - Sharp Aquos LC-32WD1E Operation Manual

Menu operations (main)

Input Label

The Input Label setting allows you to customize the label
that is displayed for each input source.
1
Press to select the input source whose label you
want to change.
2
With the input source selected, press MENU. The TV
Menu displays.
3
Press / to select Setup Menu, and then press OK.
4
Press / to select Input Label, and then press OK.
5
Use / / / to enter each letter of the new name,
and then press OK.
NOTE:
• The name can be six characters or less.
• You cannot change the label if the input source is
TV or DTV.

Position

Menu Operation: C (page 12)
The Position setting adjusts the horizontal and vertical
position of the image on the screen.
V-Pos. Moves the image up or down.
H-Pos. Moves the image left or right.
Reset Resets the settings to the factory
default.
WSS (Wide Screen
Signalling)
Menu Operation: A (page 12)
If the incoming broadcast contains wide screen signals, the
WSS setting allows the TV to automatically switch to the
appropriate screen format.
NOTE:
• To adjust the wide screen format manually, see
"Wide Mode" on page 20.

Antenna Supply Voltage

Menu Operation: A (page 12)
The Antenna Supply Voltage setting turns power "On" or
"Off" to the antenna input connection on the rear of the
television. (See page 3.)

Clock Menu

Menu Operation: C (page 12)
The Clock Menu setting allows you to set a 12-hour or 24-
hour clock and set the time manually.
NOTE:

Option Menu

TV/DTV/AV only

Input Select

TV/DTV/AV only
Menu Operation: A (page 12)
The TV will automatically detect the type of input for EXT1,
EXT2, or EXT3. However, this can be set manually if
desired. (For example if the image is unclear.)
EXT 1, EXT 2
EXT 3

Audio Only

Menu Operation: A (page 12)
The Audio Only setting turns off video and only plays the
audio from the source.
DNR (Digital Noise
Reduction)
Menu Operation: C (page 12)
The DNR setting (Digital Noise Reduction) produces a
clearer image by reducing digital noise. Available options
are High, Low, and Off.
• Press / to select 12/24 Hours Selection.
Press / to set this setting to 12 Hours or 24
Hours.
• Press / to select Set Time. Press 0–9 to enter
the current time.
• If teletext information is available, the TV will
automatically synchronize with the time included
with the teletext information.
Y/C (S-Video), RGB, CVBS
Y/C (S-Video), CVBS
TV/DTV/AV only
18