Supplied Accessories; Quick Start Guide; Setting Up The Tv - Sharp Aquos LC-32WD1E Operation Manual

Supplied accessories

Remote control unit (x1)
(For Europe, except
U.K. and Eire)
included with model LC-32WD1E

Quick start guide

Setting up the TV

2
AC cord
1
To receive analogue or digital terrestrially broadcasted stations, connect the antenna cable (from the antenna/cable
socket or the room/roof antenna) to the input antenna port on the back of the television. If there is good reception, an
indoor antenna can also be used. If you are using an active antenna, the supply voltage (5V) must also be set. (See
page 18.)
2
Connect the AC cord to the power port on the back of the television.
3
Plug the AC cord into the AC outlet.
WARNING! IT IS THE RESPONSIBILITY OF THE INSTALLER TO MAKE SURE THE TELEVISION IS INSTALLED
! SAFELY. IF YOU ARE USING ANY ACCESSORIES WITH THIS TELEVISION (SUCH AS A WALL
MOUNT BRACKET OR A TELEVISION STAND), FOLLOW THE ACCESSORY MANUFACTURER'S
SPECIFICATIONS AND INSTALLATION INSTRUCTIONS.
AC cord (x1 or x2)
(For U.K. and Eire)
U.K. type 3-pin AC cord is only
Page 3
Place the TV close to
the AC outlet, and keep
the power plug within
reach.
Batteries (x2)
AA
•
Operation manual (This publication)
1
3
Cable clamp (x1)
Cable tie (x1)
(For Europe, except
U.K. and Eire)
(For U.K. and Eire)
3