Specifications - Sharp XL-UR230H Operation Manual

Specifications

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product im-
provement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
General (XL-UR230H)
Power source AC 230 V, 50 Hz
Power Power on: 100 W
consumption
Power stand-by: 0.6 W(*)
Dimensions Width: 175 mm (6-3/4")
Height: 240 mm (9-1/2")
Depth: 315 mm (12-1/5")
Weight 5.45 kg (11.7 lbs.)
General (XL-UR250H)
Power source AC 230 V, 50 Hz
Power Power on: 90 W
consumption
Power stand-by: 0.6 W(*)
Dimensions Width: 175 mm (6-3/4")
Height: 240 mm (9-1/2")
Depth: 315 mm (12-1/5")
Weight 5.4 kg (11.7 lbs.)
General (XL-UR2110H)
Power source AC 230 V, 50 Hz
Power Power on: 60 W
consumption
Power stand-by: 0.6 W(*)
Dimensions Width: 175 mm (6-3/4")
Height: 240 mm (9-1/2")
Depth: 315 mm (12-1/5")
Weight 4.9 kg (10.8 lbs.)
( * )This power consumption value is obtained when the demonstration
mode is cancelled in the power stand-by mode. Refer to page 8 to
cancel the demonstration mode.
Amplifier (XL-UR230H)
Output power PMPO: 364 W
MPO: 182 W (91 W + 91 W) (DIN 45 324)
RMS: 100 W (50 W + 50 W) (DIN 45 324)
RMS: 76 W (38 W + 38 W) (DIN 45 500)
Output terminals Speakers: 6 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Subwoofer pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Input terminals Video/Auxiliary (audio signal):
500 mV/47 k ohms
Amplifier (XL-UR250H)
Output power PMPO: 660 W
MPO: 330 W (165 W + 165 W) (DIN 45 324)
RMS: 160 W (80 W + 80 W) (DIN 45 324)
RMS: 128 W (64 W + 64 W) (DIN 45 500)
Output terminals Speakers: 6 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Subwoofer pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Input terminals Video/Auxiliary (audio signal):
500 mV/47 k ohms
Amplifier (XL-UR2110H)
Output power PMPO: 160 W
MPO: 80 W (40 W + 40 W) (DIN 45 324)
RMS: 40 W (20 W + 20 W) (DIN 45 324)
RMS: 26 W (13 W + 13 W) (DIN 45 500)
Output terminals Speakers: 6 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Subwoofer pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Input terminals Video/Auxiliary (audio signal):
500 mV/47 k ohms
XL-UR230H
XL-UR250H
XL-UR2110H
ENGLISH
E-40