Planning The Installation; Preparation For Installation - Lopi 1250 Owner's Manual

Stove Installation
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death. Contact
local building or fire officials about restrictions and installation inspection requirements in
your area.
Always use gloves when operating a hot stove. The door handle and other components become very
hot during normal use.

Planning the Installation

We suggest that you have an authorized Travis Industries dealer install your stove. If you install the
stove yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this stove and notify your
insurance company before proceeding with installation.

Preparation for Installation

The stove can be lightened by removing the firebricks and baffle (pg. 25) - replace before operation.

Check for damage to the exterior of the stove.

Check the interior of the firebox (replace
cracked firebrick and make sure baffle is in
place).

The stove must be installed with the legs (see
page 30) or pedestal (see page 30).

Attach the convection air deflector (shipped
inside the stove) using the three screws
included in the owner's pack- see Figure 2.
© Travis Industries
(for qualified installers only)
100-01277
7
Figure 2
4111111