Leveling Bolt Installation - Lopi Answer Owner's Manual

Wood stove / inbuilt

Hide thumbs Also See for Answer:

Table of Contents

Inbuilt Installation

Leveling Bolt Installation

Two leveling bolts are included to level the insert if the fireplace has a stepped-up hearth. To install, raise

the rear of the insert up and insert the leveling bolts into the holes in the rear corners of the insert. Adjust

the bolts until they extend the same height as the hearth steps up. After the insert is installed, fine-tune

the leveling bolts to level the insert.

This distance is the

hearth step-up. The

leveling bolts should

stick out this far from the

base of the insert.

Flue Installation



The flue must be 6" (150mm) diameter stainless steel.



Use a starter section and screws to secure the flue to the insert.

Fireplace

Hearth

(for qualified installers only)

100-01278

The leveling bolts go

into the holes at the

rear corners of the

insert.

Figure 14

4111128

Table of Contents